Will Not Buckle or Bend
Saves Time
12 Month Warranty
Australian Made Product
Will Not Buckle or Bend
The Ferret’s rigid body is made from a flexible yet tensile fibreglass reinforced polymer, which helps it retain its original shape.
Saves Time
Designed for single-person use, The Ferret has a simple application process that anyone can follow to efficiently get the job done.
12 Month Warranty
We’re confident that you won’t experience any quality issues with The Ferret, so every purchase is backed by a 12-month warranty.
Australian Made Product
For guaranteed quality assurance and to support our local economy, The Ferret is manufactured and assembled by qualified trades right here on our door stop.
PRODUCTS
Retains straightness when uncoiled, but will flex in the intended direction.
Non-conductive material with High tensile strength & outstanding durability.
Ideal for wall cavities, suspended ceilings & confined spaces.
Capable of horizontal, corner, diagonal wiring, top-down & bottom-up wiring.
Long and rigid enough to travel up the wall cavity of a two storey building (8 meter only).
Looking for an easier way? Invest in an Australian made solution for all your cabling!
Guide Wheel (Head)
The unique flexible head contains a roller wheel to aid in gliding over mortar, bricks and hard edges with ease. The head has flex fatigue resistance, reflective memory and spring-like properties.
Body
Made out of fibreglass-reinforced polymer, the body is rigid enough to maintain direction, whilst being flexible enough to manoeuvre around corners and past obstructions. Its low flexural modules enable it to bend, and then return to its original state.
Tail & Hook Attachment
The Ferret’s tail facilitates dual use for threading and taping of wires, as well as the fitting of the hook attachment to fish cables that are difficult to reach.
TESTIMONIALS
HEAR FROM OUR
VALUED CLIENTS
Looking for and easier way? Invest in Australia's Most Versatile Cabling Solution!
Electrical Wiring
IT Data Cables
Security System Cables
Telephone Wiring
TV Antennas
Others
The Application Process
Step 1
Identify an existing opening or drill a minimum 20mm diameter hole into the surface to create an entry point.
Step 2
Tie the cable to the tail end of The Ferret ready to be pulled, and insert the head (wheel end) into the opening.
Step 3
Direct it using the body in alignment with the intended direction and feed it through until it reaches the required location.
Step 4
Pull the Ferret through the opening to reveal the cable, and untie ready for use. Then Coil it up ready for the next job!
